MacDon FD75 OM User Manual
Page 391
Advertising
4.
Release bushing clamps (A) using a small screwdriver
to separate the serrations. Pull clamp off tine tube.
Figure 6.263: Bushing Clamp
5.
Rotate arm (A) clear of disc and slide arm inboard off
bushing and remove bushing halves (B). If required
remove the next tine or plastic finger, so that the arm
can slide off the bushing. Refer to:
•
Removing Plastic Fingers, page 375
•
Removing Steel Tines, page 374
Figure 6.264: Bushing
Cam End Bushings
6.
At the cam end, remove endshields and endshield
support (A) at applicable tine tube location on the
cam end.
Figure 6.265: Cam End
169894
377
Revision A
Advertising