MacDon FD75 OM - Manual (Page 248)

HEADER ATTACHMENT/DETACHMENT
21. If quick disconnects are installed, disconnect as
follows:
a. Line up slot (A) in collar with pin (B) on connector.
b. Push collar toward pin, and pull connector to
disengage.
c. Install plugs or caps on hose ends (if equipped).
Figure 5.111: Quick Disconnect
22. Disconnect reel hydraulics (A). Cap off end
immediately to avoid loss of oil.
Figure 5.112: Reel Hydraulics
23. Store and secure hoses to adapter frame.
24. Ensure header is on ground, or is supported by wheels
in transport mode.
25. Start engine, and slowly back combine away from
header.
26. Stop engine, and remove key.
Figure 5.113: Hose Storage
169894 234 Revision A