MacDon FD75 OM User Manual
Page 396
Advertising
Center Disc and Tail End Bushings
11. Position bushing halves (B) on tine tube so that lug in
each bushing half is positioned in hole in tine tube.
12. Slide reel arm (A) onto bushing (B) and position against
disc at original location.
13. Reinstall any fingers or tines that were removed.
Refer to:
•
Installing Steel Tines, page 374
•
Installing Plastic Fingers, page 375
Figure 6.276: Tail End
14. Install bushing clamps (A) by spreading clamp (A)
and slip over tine tube adjacent to flangeless end
of bushing.
15. Position clamp on bushings (B) so that edges of clamp
and bushing are flush when clamp fits into groove on
bushing and lock tabs are engaged.
Figure 6.277: Bushing
169894
382
Revision A
Advertising