MacDon FD75 OM - Manual (Page 88)

OPERATION
7. Select HEADER HEIGHT/TILT (A). The PARAMETER
window opens.
Figure 4.71: Combine Display
8. Select Left header height sen (A), and then select the
Graph button at the bottom of the screen. The exact
voltage is displayed at top of screen. Raise and lower
the header to see the full range of voltage readings.
9. If the sensor voltage is not within the low and high
limits, refer to
Height Sensor Output Voltage Range
– Combine Requirements, page 58 , or if the range
between the low and high limits is insufficient, you
need to make adjustments. Refer to
Adjusting Voltage
Limits, page 60 .
Figure 4.72: Combine Display
10. Push the GRAPH tab beside the SETTINGS tab to view
the voltage.
Figure 4.73: Combine Display
169894 74 Revision A