MacDon FD75 OM - Manual (Page 197)

OPERATION
10. Lock wheel (A) with pin (B). Move the right axle (C) to
front of header.
Figure 4.279: Right Rear Wheel
11. Remove pin (A), raise support (B) to position shown,
and reinsert pin (A).
IMPORTANT:
Ensure pin (A) engages the tube on the axle.
12. Swing brace (C) into position as shown and insert
brace into slot (D) behind cutterbar. Position brace so
that pin (E) engages hole in bracket (F). Right hand
wheel is now in Transport position.
13. Disengage the header cylinder lift stops.
14. Detach the header’s hydraulic and electrical
connections from the combine. See 5 Header
Attachment/Detachment, page 189 .
15. Start combine and lower header to the ground.
Figure 4.280: Positioning Right Rear Wheel
169894 183 Revision A