MacDon FD75 OM - Manual (Page 309)

MAINTENANCE AND SERVICING
4. From inside the auger, remove hairpin (A), and pull tine
(B) out of bushing (C).
5. From inside the auger, swivel tine away from bushing,
pull from plastic guide (D), and remove from auger.
Figure 6.79: Auger
A - Hairpin B - Tine
C - Bushing D - Plastic Guide
NOTE:
If the sixth tine (A) opposite drive side is being
replaced, it also must be slipped off drive tube
(B). This particular tine cannot be removed for
normal operation.
6. If tine is not reinstalled, proceed to next step.
Otherwise, Refer to
Installing Feed Auger Tines, page
296 .
Figure 6.80: Inside Auger
7. Remove screws (A) securing plastic guide (B) to auger,
and remove guide from inside auger.
Figure 6.81: Auger
169894 295 Revision A