Rockwell Automation 1302 575v AC Drive - Canada Only - Manual (Page 51)

Chapter
7
7–1
Publication 1302-5.0 — January, 1998
Display and Keypad Operation
The Keypad and Display unit shown in Figure 7.1 is used to
program, monitor and control the Drive. The Keypad and Display
unit operates in two modes: Monitor Mode and Program Mode.
In Monitor Mode (the default mode), you can monitor specific Drive
outputs and the Drive’s speed reference.
In Program Mode, you can view and adjust Drive parameter values
and examine the error log.
I n addition to the functions above, if the control source is local (F-00
= 0), you use the keypad to start and stop the Drive, select motor
direction, and adjust speed.
Regardless of the control source selected, you can use the keypad to
stop the Drive and reset Drive faults.
The following sections describe the keypad, the display, and the
LEDs. Monitor mode and program mode are described in more
detail later in this chapter.
Figure 7.1
1302 Keypad and Display
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
The display is a four-character, seven-segment LED. At Drive
power up, SELF is displayed while the Drive performs power-up
diagnostics. During Drive operation, the display indicates parameter
numbers, parameter values, fault codes, and Drive output values.
Figures 7.3 and 7.4 show sample displays.
Introduction
Display Description