Rockwell Automation 1302 575v AC Drive - Canada Only - Manual (Page 59)

Chapter
8
8–1
Publication 1302-5.0 — January, 1998
Programming
To program the 1302 Drive for a specific application, you display the
appropriate parameter and adjust it as required. The parameters
specify characteristics of the Drive. This chapter describes how to
access, display, and modify parameters. Parameters are described in
detail later in this chapter. Appendix C lists the parameters in
alphabetical order.
Displaying or Changing Parameter Values
Use the following procedure to display or change parameter values:
Step 1. Stop the Drive (if it is running) by pressing the
STOP
RESET key.
Step 2. Enter program mode by pressing the
Mode
Enter
key until the
PROGRAM LED turns on.
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
The first parameter number (F-00) will be displayed.
Step 3 Press the or key until the desired parameter
number is displayed.
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Each parameter number will be displayed as you scroll through the
parameter list.
Step 4. Press the
Mode
Enter
key to display the parameter value.
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Introduction