Monitor mode – Rockwell Automation 1302 575v AC Drive - Canada Only User Manual
Page 56
7–6
Display and Keypad Operation
Publication 1302-5.0 — January, 1998
For information about:
Refer to chapter:
Displaying or changing parameter values
8
Ensuring program security
8
Individual parameters
8
Accessing the error log
9
Monitor mode is the keypad and display’s default mode of operation
(in other words, the keypad and display will return to monitor mode
when you exit program mode). The keypad and display must be in
monitor mode before the Drive can be put into run (RUN LED is on)
and will remain in monitor mode while the Drive is running.
The following output data can be displayed in monitor mode:
•
RPM
•
% Load
•
Volts
•
Percent Selected Speed Reference (if F–13 = ON)
To select a value to monitor, press the
Mode
Enter
key until the LED turns
on next to the desired display item. Pressing the
Mode
Enter
key will
advance you through each of the displays. (Note that all the LEDs
will turn on to indicate the percent selected speed reference display if
parameter F-13 is set to ON. Refer to the scaling the rpm section of
this Chapter.)
A sample monitor mode display is shown in Figure 7.4
.
Figure 7.4 - Example of a Monitor Mode Display
Mode
Enter
START
Forward
Reverse
STOP
RESET
RPM
%Load
Volts
Remote
RUN
Program
Forward
Reverse
Monitor Mode