Rockwell Automation 1302 575v AC Drive - Canada Only User Manual
Page 57
7–7
Display and Keypad Operation
Publication 1302-5.0 — January, 1998
Displaying the Percent Selected Speed Reference
To display the percent selected speed reference, parameter F-13 must
be set to ON. Use the following procedure to display the percent
selected speed reference:
Step 1. Stop the Drive (if it is running) by pressing the
STOP
RESET
key.
Step 2. Enter program mode by pressing the
Mode
Enter
key until the
PROGRAM LED turns on.
Step 3. Press the
or
key until F-13 is displayed.
Step 4..
Press the
Mode
Enter
key to access the parameter.
Step 5.. Press the
key until ON is displayed.
Step 6.. Press the
Mode
Enter
key to save the value. (F-13 will be
displayed.)
Step 7.. Press the
STOP
RESET
key to exit program mode.
Step 8.. Start the Drive by pressing the
START
key.
Step 9.. Press the
Mode
Enter
key until all three monitor mode LEDs are
on.
The display will show the active speed reference as 1 to 100% of
maximum speed (F-04).
Scaling the RPM Display and Reference Using F–08
The RPM display and reference can be scaled to an engineering unit
to match your application. Refer to the F-08 description in Chapter 8
for this procedure.