Rockwell Automation 1512B MV Controllers, 200/400A Two-High Cabinet, Standard and Arc-Resistant Enclosure - Manual (Page 24)

16 Rockwell Automation Publication 1500-UM055G-EN-P - May 2013
Chapter 2 Installation – Standard Enclosure
17. Reverse the procedure to reassemble the cabinet. Ensure that the barriers
are put back in place and all parts and tools are accounted for.
Figure 15 - Access to Right Side of Power Bus
Front Access – Bottom Exiting Load Cables
If the cables in your cabinet exit from the bottom, the procedure to access the power
bus is almost identical to the one above. Follow the procedure for
Top Exiting Load
Cables on page 19 , but remove the cable duct barrier and cable duct boot from the
top of the lower power cell, rather than those at the bottom (see Figure 16 ).
Remove self-tapping screws
ATTENTION: Ensure all barriers are replaced before re-energizing the
equipment. Failure to do so may result in electrical faults and cause damage to
equipment or serious injury to personnel.