Rockwell Automation 1408-EMxx PowerMonitor 1000 Unit - Manual (Page 3)

3 Publication 1408-UM001B-EN-P - May 2008 3
Summary of Changes
Introduction This release of this document contains new and updated information.
The information below summarizes the changes to this manual since
the last publication.
Revision bars in the margin identify updated information. Changes for
this version of the document include:
Change Page
Added DH485 to the serial communication
protocol table. 10
Added section with information about
DH485. 11
Added that the Ethernet communication
port supports 10 or 100 Mbps data rate,
half-duplex, or full-duplex. 11
Added DH485 to the communication
command summary. 15
Added information about explicit messaging
instructions apply to Ethernet
communication and serial communication. 17
Added instructions to configure RSLinx
software driver configuration for DH485. 34
Added information for using the DH485
driver. 37
Added information for OPC tag browsing. 39
Added information about a user configured
data table. 40
Added User Configured Table Results
Parameters table. 45
Added User Configured Table Results table. 45
Added element 5 to Analog Input
Configuration table 46
Updated elements 5 and 7 to Advanced
Configuration table. 48
Updated Serial RS-485 Port Configuration
table. 51
Updated Command table. 61
Added element 10 to the Log Request table. 64
Updated Wiring Diagnostics Results table. 68
Updated Unit Run Status Results table. 80