Configure the ab_eth/ip driver – Rockwell Automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual User Manual
Page 112
Advertising
106
Rockwell Automation Publication 1734-UM017B-EN-P - October 2013
Appendix C Configure the RSLinx Ethernet Communication Driver
Configure the AB_ETH/IP
Driver
To configure the AB-ETHIP Ethernet communication driver, perform the
following steps.
1. Start the RSLinx software.
2. From the Communications menu, select Configure Drivers.
3. Select EtherNet/IP Devices from the list and click Add/New...
Advertising
This manual is related to the following products: