Rockwell Automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual - Manual (Page 72)

64 Rockwell Automation Publication 1734-UM017B-EN-P - October 2013
Chapter 5 Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software
Add the POINT I/O Modules and Configure for Rack-optimized
Connection
You must now add the ArmorPoint I/O modules to the I/O Configuration List
under the adapter. In this example, the digital input and output modules are
configured for rack optimization.
Add the Digital Relay Output Module
1. Right-click the POINT I/O Chassis in the I/O Configuration folder and
select New Module
…
The Select Module Type dialog displays.
2. Select the appropriate filter for Module Type Category (for the example we
selected Digital) and Module Type Vendor (for the example we selected
Allen-Bradley).
Note: to select only one category you will need to unselect those already
selected.
3. From the modules listed select the 1734-OW2 digital relay output module
and click Create.
TIP In the Select Module Type dialog, you have options to search for a
specific module, add modules to a Favorites list, filter by Category
and/or Vendor, Hide and Show Filters, use Module Discovery, sort by
vendor, or access your Favorites list.