Rockwell Automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual User Manual
Page 57
Advertising
Rockwell Automation Publication 1734-UM017B-EN-P - October 2013
49
Configure the Adapter for Direct Connection in RSLogix 5000 Software Chapter 4
3. Select Properties.
4. Click the Connection tab.
The Module Fault error code displays.
5. Click the Chassis Size tab.
6. Click Set Chassis Size in Module.
Value from
Module Properties
General Tab
Value currently
stored in 1734-
AENTR
adapter
Advertising
This manual is related to the following products: