Add the digital sink output module – Rockwell Automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual User Manual
Page 74
66
Rockwell Automation Publication 1734-UM017B-EN-P - October 2013
Chapter 5 Configure the Adapter for Direct Connection and Rack Optimization in RSLogix 5000 Software
7. In the New Module screen select the Connection tab and verify that the
Requested Packet Interval (RPI) used for the rack-optimized connection
to the I/O modules is appropriate for your system (80.0 ms for this
example). If not, change it to the correct value.
8. Click OK to accept the configuration.
The digital output module appears indented under the local
1734-AENTR/B adapter in the I/O Configuration folder.
Add the POINT I/O Module and Configure For Direct Connection
Add The Digital Sink Output Module
1. Right-click the POINT I/O Chassis in the I/O Configuration folder and
select New Module
.
The Select Module Type dialog opens.