Overview, Chapter 2, Install your point i/o or armorpoint i/o adapter – Rockwell Automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual User Manual
Page 17: Chapter
Rockwell Automation Publication 1734-UM017B-EN-P - October 2013
9
Chapter
2
Install Your POINT I/O or ArmorPOINT I/O
Adapter
Overview
This chapter describes how to physically install the POINT I/O and
ArmorPOINT I/O Series B Dual Port EtherNet/IP adapters; and how to
connect the adapter to the EtherNet/IP network.
This chapter includes the following topics:
Topic
Page
Mount the POINT I/O Adapter on a DIN Rail
Mount the ArmorPOINT I/O Adapter on a Panel or Wall
Install ArmorPOINT I/O Modules
Wire an ArmorPOINT I/O Adapter
ATTENTION: You must only use Series C and above POINT I/O modules
with POINT I/O Adapters. Series A or Series B POINT I/O modules do not
work with POINT I/O Adapters (does not apply to POINTGuard modules).
ATTENTION: To comply with the CE Low Voltage Directive (LVD), this
equipment must be powered from a source compliant with the
following:
Safety Extra Low Voltage (SELV) or Protected Extra Low Voltage (PELV).