Rockwell Automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual - Manual (Page 24)

16 Rockwell Automation Publication 1734-UM017B-EN-P - October 2013
Chapter 2 Install Your POINT I/O or ArmorPOINT I/O Adapter
Wire the Adapter The POINT I/O adapter uses RJ45 EtherNet/IP connectors for its EtherNet/ IP
connections; the ArmorPOINT I/O adapter uses M12 Female in connectors for
its EtherNet/IP connections and one 4-pin Mini-Style Male in connector for the
Auxiliary Power connection. Connect the cord sets you selected for your module
to the appropriate ports.
Wire a POINT I/O Adapter
Refer to the following illustration to wire the adapter.
ATTENTION: Do not connect 120/240V AC power to this supply. This
DC supply will be connected to the internal power bus.
0 2 0 1734-AENTR Series B
Module
Status
Network
Activity
Network
Status
Point Bus
Status
System
Power
Field
Power
POINT I O
Link 1
Activity/
Status
Link 2
Activity/
Status
IP ADDRESS
Chas Gnd
C
V
NC
Ethernet RJ-45
connectors
NC = No Connection
Chas Gnd = Chassis Ground
C = Common
V = Supply
This DC supply connects
to the internal power bus.
NC
V
NC
Chas
Gnd
V
0
4
2
6
Chas
Gnd
1
5
3
7
V DC
C C