Rockwell Automation 1738-AENTR, Series B POINT I/O and ArmorPOINT I/O Dual Port EtherNet/IP Adapters User Manual - Manual (Page 3)

Rockwell Automation Publication 1734-UM017B-EN-P - October 2013 i
Preface
Read this preface to familiarize yourself with the rest of the manual. It provides
information concerning:
• who should use this manual
• the purpose of this manual
• related documentation
• conventions used in this manual
Who Should Use this
Manual Use this manual if you are responsible for designing, installing, programming, or
troubleshooting control systems that use 1734 POINT I/O
® or
1738 ArmorPOINT I/O ® Dual Port EtherNet/IP Adapter Modules.
Purpose of this Manual This manual is a reference guide for the 1734-AENTR, 1738-AENTR Series B
POINT I/O Dual Port EtherNet/IP and ArmorPOINT I/O Dual Port
EtherNet/IP Adapters, communications adapters for POINT I/O modules. It
describes the procedures you use to install, wire, configure, troubleshoot, and use
your module.
Related Documentation
The following documents contain additional information concerning Rockwell
Automation products. To obtain a copy, contact your local Rockwell Automation
office or distributor.
ATTENTION: You must only use Series C and above POINT I/O
modules with 1734-AENTR EtherNet/IP Adapters. Series A or Series B
POINT I/O modules do not work with 1734-AENTR EtherNet/IP
Adapters (does not apply to POINTGuard modules).
Resource Description
1734 POINT I/O Selection Guide, publication 1734-SG001 A description and overview of the 1734 series I/O modules and compatible
control platforms.
EtherNet/IP Design Considerations Reference Manual, publication
ENET-RM002 .
Using EtherNet/IP for Industrial Control.
EtherNet/IP Modules in Logix5000 ™ Control Systems User Manual,
publication ENET-UM001
A manual describing how to use EtherNet/IP modules with Logix5000
controllers and communicate with various devices on the Ethernet network.
EtherNet/IP Embedded Switch Technology Application Guide,
publication
ENET-AP005
Describes how to install, configure, and maintain linear and device-level Ring
(DLR) networks using Rockwell Automation EtherNet/IP devices with
embedded switch technology.
ControlLogix ® Chassis and Power Supplies Installation
Instructions, publication 1756-IN005 .
Describes how to install and troubleshoot standard and ControlLogix-XT
versions of the 1756 chassis and power supplies, including redundant power
supplies.
ControlLogix EtherNet/IP Bridge Module Installation Instructions,
publication 1756-IN019
ControlLogix EtherNet/IP Bridge Module installation instructions.
ControlLogix System User Manual, publication 1756-UM001 Detailed information on how to install, configure and troubleshoot the
ControlLogix Sequence of Events module in your ControlLogix application.