Rockwell Automation Motion Analyzer Software - Manual (Page 222)

222 Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012
Chapter 3 Understanding Your System Solution
3.2.2.2. Tolerance/Design Analysis
When you click Tolerance/Design Analysis, the following dialog box opens.
The buttons below the Tolerance Analysis chart are available to select which
curves are displayed. When you click Selected Curves, the parameters selected on
the Graph tab (right of the chart) are displayed. If you select another button
below the chart, only that parameter appears.
The slider below the chart is available to adjust the selected Profile, Load, or
Actuator parameter. As you mouse over the slider, the parameter value is
displayed.