Rockwell Automation Motion Analyzer Software - Manual (Page 45)

Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012 45
Welcome to Motion Analyzer Software Chapter 1
Figure 31 - Control Power Tab (details revealed)
1.2.2.4.2.5. Configure IPIM Module BOM Tab
Click the Configure IPIM Module BOM tab to select hybrid and network
cables, and other IDM system accessory items.
Figure 32 - Configure IPIM Module BOM Tab
Table 26 - Configure IPIM Module BOM Tab Descriptions
Figure 33 - Configure IPIM Module BOM Tab
Options Description
Step 1 ( Figure 32 ) IPIM module IPIM module selected on the IPIM Module tab is displayed here.
Step 2 ( Figure 32 ) Hybrid cables Hybrid cable lengths selected on the Cable Lengths tab are displayed here.
Step 3 ( Figure 32 ) Network cables
Network cables can be routed with the hybrid cables, so network cable lengths
should be the same as the hybrid cable. The IPIM-to-IDM1 cable must have a
straight connector to the IPIM module.
Step 4 ( Figure 32 ) Hybrid coupler The hybrid coupler connects between two hybrid cables, to bypass an IDM unit.
Step 5 ( Figure 33 )
Network
bulkhead adapter Use the network bulkhead adapter for securing network cables as they pass
through the cabinet.