Crank template – Rockwell Automation Motion Analyzer Software User Manual
Page 93
Advertising
Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012
93
Sizing Your System
Chapter 2
2.1.3.2.2. Crank Template
The Crank template is used to calculate the load profile for a given application,
based on either input shaft velocity or linear load velocity.
Figure 75 - Crank Template
Figure 76 - Animated Display (for reference)
IMPORTANT
This template should only be used for constant inertia. Do not set secondary
mass or secondary inertia when using this template.
TIP
Parameter entry descriptions are displayed when the cursor is held over an
entry field for several seconds.
Advertising