Rockwell Automation Motion Analyzer Software - Manual (Page 225)

Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012 225
Understanding Your System Solution Chapter 3
3.2.2.2.3. Actuator Tab
Follow these steps to adjust the actuator parameters.
1. Select the Actuator parameter you would
like to analyze.
This becomes the parameter corresponding
to the X-axis on the graph. The number
next to each parameter indicates the
parameter value based on the current system
configuration.
2. Adjust the selected actuator parameter range
and number of steps in the Low, High, and
Steps text boxes, as needed.
3. Click Plot Graph to refresh the chart when
you have finished entering the values.
This tab is not available for the Rack and
Pinion and Sprocket loads.
4. Click Setup to enter all of the ranges and numbers of steps for the Actuator
Tolerance Parameters in the Tolerance Analysis - Setup dialog box.
5. Select whether to enter data ranges as Percentages of nominal values or as
actual Values.
6. Enter the Low, High, and Steps values in the text boxes.
7. Click OK.