Graph tab – Rockwell Automation Motion Analyzer Software User Manual
Page 226
Advertising
226
Rockwell Automation Publication MOTION-UM004B-EN-P - October 2012
Chapter 3
Understanding Your System Solution
3.2.2.2.4. Graph Tab
This tab is not available for the Rack and Pinion and Sprocket loads.
Follow these steps to decide which parameters are displayed.
1. Check the Motor Parameter curves to
display.
2. Check the Drive Parameter curves to display.
3. Click Setup to enter all the ranges and
numbers of steps for the Profile, Load, and
Actuator tolerance parameters.
4. Click Return to exit.
Advertising