Metrohm 914 pH / Conductometer - Manual (Page 57)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Operation
pH Meter/Conductometer
￭￭￭￭￭￭￭￭ 47
￭ off: is the default setting
K
c lower limit Editing dialog for the entry of the lower limit value.
￭ Default value: 0.400 /cm / input range: 0.001 - 500 /cm
K
c upper limit Editing dialog for the entry of the upper limit value.
￭ Default value: 0.550 /cm / input range: 0.001 - 500 /cm
Delete sensor Selection dialog for deleting a sensor.
The data will be irreversibly deleted.
4.7.5 Report
The Report menu dialog is shown below with the structure and the
description.
NOTE
Printer
pH Meter/Conductometer instruments support various printer types for
report output. If your printer is not listed, please use the printer
Universal (ESC-POS), which has appropriate setting parameters.
Report Selection dialog for data output in the Report.
￭ Calibration pH
￭ Calibration pH IS
￭ Calibration κ
￭ Sensors
￭ Configuration
￭ Parameters pH
￭ Parameters pH IS
￭ Parameters κ
￭ Meas. values
￭ All reports
Line feed Editing dialog to indicate the lines to be inserted at the end of the report.
￭ Default value: 2 lines / input range: 0 - 99 lines
Printer Selection dialog to indicate the printer for report output.
￭ HP Officejet Pro
Page printer with paper size A4
￭ HP Laserjet Pro
Page printer with paper size A4
￭ Epson (ESC-POS)
Roll printer with paper width 80 mm