Operating procedure, Controller start up – Canon GM-1000 User Manual
Page 47
CANON Digital Galvano Scanner System GM-1000 Series
Users Manual 1.20
47
4.
Operating Procedure
This chapter explains how to use the system.
Operations by [Control Software] and by [RS-232C command] are explained together.
4.1. Controller Start Up
When the power (+5 V, +24 V) is turned on, the controller execute the following automatically:
・
Read saved parameters from ROM
・
Home to the origin
・
Correct the encoder (high-speed oscillation of a fixed angle)
It takes about 15 seconds until the controller is started up.
With the default settings at shipping, the controller is started up with RS-232C communication
command input (internal clock) mode.
The completion of start up can be confirmed as follows:
Control Software
Changes to
‘CONNECT’
Light on