Canon GM-1000 - Manual (Page 61)

CANON Digital Galvano Scanner System GM-1000 Series
Users Manual 1.20
61
4.4. Position Command Input by High-speed Serial Communication
In order to carry out a vector scan, target position data is given to the controller by high-speed serial
communication, and the data is updated as required.
It is possible to change the mode of the controller to the mode of receiving target position data by
high-speed serial communication. For changing the mode, it is necessary to enter high-speed serial
communication signals into the controller in advance.
Control Software
・ Switch HiSpeed Serial to Start. ①
This switching makes the controller follow target position data by high-speed serial communication.
・ Switch HiSpeed Serial to OFF. ②
Input of the MOVE command is awaited.
RS-232C commands
・ Switch to high-speed serial communication (Command ID = 23 Data = 7)
・ Return to internal clock operation (Command ID = 23 Data = 0)
①