Arc Machines 227 - Manual (Page 52)

MODEL 227
OPERATION MANUAL
Doc # 740063 Rev E
SECTION V - OPERATION
5.7 SET UP FUNCTIONS
1. OPERATE MODE SET UP SCREENS
4. REV - Pressing the F key under this will show the current software
REVISION installed. This can be important when discussing problems or
features with an AMI representative.
NOTE
The following SET UP functions are accessed by pressing NEXT SCREEN
from the first SET UP screen.
5. Print EMM - Pressing the F key under this choice will create a Print out of
the LIBRARY contained in M-207-EMM Option (EMM must be installed).
6. AMP - TIME - This feature allows the user to change the programmable
increments of LEVEL AMPS or LEVEL TIME from 000 (whole numbers)
to 000.0 (tenths) .
NOTE
This is not on an individual WELD # basis. All WELD # will be changed
automatically. If a WELD # was originally programmed for 87.7 amperes
and this is changed to whole numbers the WELD # when accessed will then
call for 87 amperes (it will drop the digit, not round off).
7. ARC V FAULT - This feature can turn this FAULT ON or OFF. When
ON a STUB OUT will be created if the ARC VOLTAGE goes below 5 V
or a HIGH VOLTS fault if the VOLTAGE goes over 20 V . These
conditions only occur in automatic welding if something is wrong .
However, in manual welding these conditions can occur without anything
being wrong . THIS FEATURE NEEDS TO BE SET TO OFF FOR
MANUAL WELDING .
NOTE
The following SET UP functions are accessed by pressing NEXT SCREEN
from the second SET UP screen.
8. OPERATOR ID - This feature allows the Operator to enter his name into
system memory and the M-227 will record that name onto every print out
run after a weld sequence.
9. SERIAL NUMBER - This feature allows the entry of the Power Supply
Serial number into system memory and the M-227 will record that SN# onto
every print out run after a weld sequence.
5.8