Arc Machines 227 - Manual (Page 69)

MODEL 227
OPERATION MANUAL
Doc # 740063 Rev E
SECTION VI - PROGRAMMING
6.4 TRANSFER/RECEIVE WELD SCHEDULE MEMORY
4. Press the PRO key. then press the F key above or below the word
TRANSFER. The Screen will than ask if you want to TRANSFER THE
ENTIRE LIB, RECEIVE THE ENTIRE LIB, or RECEIVE ONE WELD #.
Use the appropriate F key to select your choice and then press ENTER.
CAUTION
Prior to TRANSFERRING data from the M-227 to the M-227-EMM the M-
227-EMM the M-227-EMM memory is erased. Any data stored in the EMM
previously will be LOST. The M-227-EMM is intended to copy the ENTIRE
memory of an M-227.
Individual weld schedules CANNOT be added one at a time to the M-227-
EMM from M-227 (TRANSFER mode). Individual weld schedules CAN BE
added one at a time to the M-227 from the M-227-EMM (RECEIVE mode).
6.5 DELETE A WELD SCHEDULE
CAUTION
USE OF THIS FUNCTION WILL RESULT IN THE LOSS OF A WELD
SCHEDULE IN MEMORY.
1. The DELETE function must start from the STATUS screen and the
OPERATE mode switch must be in the PROGRAM position
2. Press the PRO key; then press the F key above or below the word DELETE.
Use the numeric keys to enter the weld schedule number to be DELETED. A
WARNING will appear that pressing ENTER will DELETE this Schedule;
VERIFY and then press the ENTER key or press the C key if you change your
mind.
Another WARNING will be given at this time to confirm that you wish to
DELETE this Schedule. Confirm and verify again and then press the Enter key
again. THE WELD SCHEDULE WILL BE DELETED at this time.
3. Deletion of a Level with in a Schedule is part of the Modify option.
6.6 PROGRAM SELECT FUNCTION
1. To initially set up which schedules can be selected from the M-227-RP press
the SET UP key on the M-227 (this operation cannot be done from the RP).
The SET UP screen can be obtained from the STATUS screen or a Weld
Schedule screen
6.6