Arc Machines 227 - Manual (Page 55)

MODEL 227
OPERATION MANUAL
Doc # 740063 Rev E
SECTION V - OPERATION
5.8 REMOTE PENDANT (RP) OPERATION
1. A complete understanding of system operation is needed for proper use of the
RP. All previous sections of this manual and all previous steps of this section
should be read before proceeding with RP operation.
2. The following functions and features are provided by the standard RP:
1. Sequence Start key 2. Sequence Stop key
3. All Stop key 4. Travel Jog CW key
5. Travel jog CCW key 6. Weld/Test Mode key
7. Wire Feed Mode key 8. Wire Feed Jog key
9. Wire Retract Jog key 10. Osc IN Jog key
11. Osc OUT Jog key 12. AVC UP Jog key
13. AVC DOWN Jog key 14. Primary Amp Override key
15. Background Amp Override key 16. Primary Wire Feed Override key
17 Background Wire Feed Override key 18. Arrow Up key
19. Arrow Down key 20. Special Function key
21. Next key 22. Prev key
23. Primary Pulse Time Override key 24. Background Pulse Override key
25. Primary Travel Speed Override key 26. Background Tvl Override key
27. Primary AVC Override key 28. Background AVC Override key
29. Osc Amplitude Override key 30. Excursion Time Override key
31. IN Dwell time Override key 32. OUT Dwell time Override key
33. 8 character digital status display
2. Items 1 to 13 above are duplicates of keys contained on the M-227 panel. They
work exactly the same as the keys on the panel. When the RP is connected
these keys and the identical ones on the M-227 panel are active at the same
times. Pressing either key will perform the function desired .
3. The 8-charter digital display is used to indicate to the operator what particular
mode or area of a weld schedule the system is in.
When the M-227 is first turned ON the RP display will say NO SEQ. This
indicates to the operator that no weld schedule has been selected. When a
schedule is selected the display will show 001 TEST. This indicates that PASS
# 1 of a Weld Schedule has been called up and that the system is in TEST mode.
At other times it may indicate WELD or FLT depending on system status.
NOTE
If the power was turned off while a weld schedule was displayed the
system will power up with that schedule displayed again. The NO SEQ display
applies to power ON when power OFF occurred without a weld schedule
displayed.
5.11