Arc Machines 227 - Manual (Page 65)

MODEL 227
OPERATION MANUAL
Doc # 740063 Rev E
SECTION VI - PROGRAMMING
6.1 CREATE A WELD SCHEDULE
2. To CREATE a weld schedule press the F key below the word CREATE
and the following screen will appear:
ENTER NEW WELD # - THEN PRESS ENTER KEY
PRESS C KEY TO CANCEL WELD PROGRAMMING
#
000
Enter the number using the numeric keys. Look at the lower screen and
confirm that the numbers entered are correct; if not, press CE and re-enter
the numbers. When correct, press the ENTER key. If the number is already
used the system will reject the number and ask the programmer to try again.
3. The description screen will appear when an acceptable weld schedule number
has been entered:
ENTER WELD OD - THEN PRESS THE ENTER KEY
PRESS C KEY TO CANCEL PROGRAMMING MODE
# OD WALL MAT HEAD
001 0.000 0.00 - - - - - - - - - -
NOTE
The weld description and all values for LEVEL 1 of the weld schedule must be
entered. They cannot be skipped, you must enter a number (even if it is 0) for
each item before progressing to the next item.
4. Enter the O.D. (in inches or millimeters) using the numeric keys. Verify the
correct number on the screen and then press the ENTER key.
5. After pressing the ENTER key follow the instructions on the screen for
entering the wall thickness.
6. The M-227 will then give you a choice of materials. Use the F key to select
the proper one and Press Enter.
7. The M-227 will then give you a choice of Weld HEADS. Use the F keys to
select the proper head, press ENTER.
8. Single Level functions will then appear:
ENTER VALUE FOR BLINKING ITEM
THEN PRESS ENTER KEY
PRE-PURGE-POST UP-SLOPE-DOWN ROT--DLY
000 000
00.0 00.0 CCW 00.0
6.2