Rice Lake Counterpart Configurable Counting Indicator - User Manual Rev. E - Version 2.5 - Manual (Page 104)

98 Counterpart Counting Scale Indicator
9.10 Regulatory Mode and Legal-for-Trade (LFT)
Note
When REGULAT is set for NONE or INDUST there are no restrictions on displaying both the weight and piece
count data.
If the unit is going to be used in Legal for Trade applications, weight and piece count data cannot be displayed at
the same time. Use the following examples to use Counterpart in Legal for Trade applications.
9.10.1 Legal for Trade and Normal Weight Mode
When in a Legal for Trade mode (REGULAT = NTEP, OIML, or CANADA) and the unit is in normal weigh mode:
• If the weight is displayed in the main area (either as a result of the DSPMODE parameter being set for
WEIGHT or the Swap Display softkey was pressed) then the piece count and unit weight are not
displayed.
• If the piece count is displayed in the main area (either as a result of the DSPMODE parameter being set
for COUNT or the Swap Display softkey was pressed) then the weight is not displayed. The unit
weight will be displayed in the left display area.
• If the unit weight is displayed in the main area (either as a result of the DSPMODE parameter being set
for UNITWEIGHT or the Swap Display softkey was pressed) then the weight is not displayed. The
piece count will be displayed in the left display area.
CTARE Allow CLEAR key to clear tare/
accumulator YES YES NO NO YES
PRTMOT Allow print while in motion NO NO NO NO YES
PRTPT Add PT to keyed tare print NO NO YES YES NO
OVRBASE Zero base for overload calculation CALIB ZERO CALIB ZERO CALIB ZERO SCALE ZERO CALIB ZERO
REGULAT / INDUST Parameter REGULAT Mode
Parameter Name Text Prompt INDUST NTEP CANADA OIML NONE
Table 9-6. REGULAT / INDUST Mode Parameters, Comparison with Effective Values of Other Modes (Continued)