Rice Lake Counterpart Configurable Counting Indicator - User Manual Rev. E - Version 2.5 - Manual (Page 43)

Configuration 37
LOTUPDT OFF
ON OFF — Changing or deleting the lot value in operation mode does not update the stored copy of
the currently loaded ID record.
ON — Changing or deleting the lot value in operation mode saves the changes into the stored
copy of the currently loaded ID record.
SCLCHG REZERO
CHKSTABLE
XFRTARE
XFRUTWT Scale change. These are actions taken when changing from one scale to another.
See SCLCHG sub-menu below.
NEWITEM OFF
ON New item. This prompts user to add an ID to memory when an unknown ID is requested from
weigh mode.
XFRSMPL OFF
ON After sample. After a sample, a switch is done from the current scale to the next scale that is
larger than or equal to the current scale. If a sample is done on the largest of the scales, a
switch will not be done.
DISPACC OFF
ON Display accuracy
UTWTUPDT OFF
ON Enables or disables the updating of the loaded ID with a new unit weight value.OFF — Parts can
be sampled (generating a new unit weight) or a unit weight can be keyed or scanned but the
new unit weight is not saved into the stored copy of the currently loaded ID record.

ON — If on, the unit weight will update the stored value whether at zero or actual value.
UTWTBASE 1000
1 Unit weight base. 1 = APW (Average Piece Weight), 1000 = Piece weight per thousand.
DISPMODE COUNT
WEIGHT
UNITWEIGHT Display mode. This chooses the value to be displayed as large in viewing window.
REMOVTSP ON
OFF Removes trailing spaces from ID Codes.
• ON — If set to on:

- an ID code configured through the ID menu will have any entered trailing spaces removed
before being stored.

- an ID code configured through the ID.CODE EDP command will have any entered trailing
spaces removed prior to being stored.

- trailing spaces will be removed from an ID Code that is entered via the Code softkey. This
includes using the front panel or USB keyboard.

- trailing spaces will be removed from an ID Code that is scanned from a barcode.
• OFF — If set to off:

- an ID code configured through the ID menu will be stored with trailing spaces as entered

- an ID code configured through the ID.CODE.EDP command will be stored with trailing
spaces as entered.

- an ID code entered via the Code softkey for recall will retain any trailing spaces. This
includes using the front panel or USB keyboard.

- an ID Code scanned from a barcode for recall will retain any trailing spaces
SCLCHG submenu
REZERO OFF
ON Performs a zero function on change.
CHKSTBLE ON
OFF When changing scales, a stability check can be either enabled or disabled. If enabled, and the
stability check is successful, no indication is shown and the unit switches to the next scale. If
enabled and the stability check fails, then NON-STABLE is shown on the display and the switch
to the next scale is not made.
XFRTARE OFF
ON When changing scales, the tare weight is transferred from the current scale to the new scale.
Units must be set to the same unit of measurement.
XFRUTWT ON
OFF When changing scales, the unit weight is transferred from the current scale to the new scale.
Table 3-11. Count Menu Parameters