Rice Lake Counterpart Configurable Counting Indicator - User Manual Rev. E - Version 2.5 - Manual (Page 70)

64 Counterpart Counting Scale Indicator
5.5.4 Clearing ID Codes
1. Press the Menu Setup key.
2. Toggle through menu items to ID .
3. Select Reg 1-150 to clear.
4. Push the Clear ID softkey.
5. The display prompts Clear ID Values . Press the Yes softkey.
6. Display shows ID Cleared .
7. Push the Menu softkey to return to the Use mode.
5.5.5 Adding an ID From Count Mode
1. Press the CODE softkey.
2. Add in the ID number. The Alpha ON/OFF Softkey appears to allow number only entry.
3. If the ID number is not already in the database, Counterpart prompts, Not Found, Save as New ID ?
4. Select Yes or No. By selecting Yes, Counterpart will store that ID code into the first open register. By
selecting No, you will go back to the Counting mode screen.
5. Optional – Sample Quantity desired and press the UW Update softkey
6. Optional – Tare the container and push the Tare Update softkey.
5.5.6 Adding an ID Through Revolution
To add an ID using Revolution, you must have Revolution installed on your computer. Visit www.ricelake.com to
download this free configuration software.
1. Unplug power to Counterpart.
2. Wire cable between computer and Counterpart.
3. Plug in power to Counterpart and press Counterpart’s POWER key.
4. Open Revolution and go to Base Configuration, >> IDs.
5. To upload IDs from Counterpart, select Connect from the Toolbar or under Communications — Connect .
6. Select Communications and then Upload Configuration or Upload Section.
7. Select REG # and add information into the screens as shown in Figure 5-2.
Figure 5-2. Adding IDs Through Revolution