Rice Lake Counterpart Configurable Counting Indicator - User Manual Rev. E - Version 2.5 - Manual (Page 69)

Scale Operations 63
5.5.1 Setting an ID Using the Normal Mode
1. Press the MENU SETUP key MENU
SETUP
to access this menu.
2. Press to ID and then press and you will be at REG1.
3. Navigate to the REG number you want to set (1-150) by using the and keys.
Note
All menus have wrap-around functionality. If you are at ID1 and want to access ID150, you can quickly do so by
moving backwards through the menu.
4. When you have reached the REG number you want to set, press to select that register number.
5. Press
and enter the CODE value — either the numeric or alphanumeric is acceptable. Thirty two
characters can be entered and only 25 characters maximum for default bar code formats. This code will be
used to recall the ID.
6. When the desired value is entered, press TARE (Enter) .
7. Enter the information for description, part number, lot number, unit weight, tare with all entries being
optional.
8. Press TARE (Enter) again to accept the value(s).
9. Press to advance back up to REG. Press again, and the DONE softkey is displayed.
10. When complete, push the DONE softkey.
Enter Lot Number — Optional
1. LOT will be displayed. Press key to enter the alphanumeric value using the Counterpart keypad.
2. Press the TARE (Enter) key to accept.
Enter Unit Weight — Optional
1. UNIT WT will be displayed. Press and enter the unit weight value using the Counterpart keypad.
2. Press the TARE (Enter) key to accept.
Enter Tare — Optional
1. TARE will be displayed. Press and enter the tare value using the Counterpart keypad.
2. Press the TARE (Enter) key to accept.
Enter Units — Optional
1. UNITS will be displayed. To adjust the units, use the and keys to adjust the selection or press to view
the current setting.
2. Use the key or the TARE (Enter) key to store the setting.
Enter Location — Optional
1. LOCATION is displayed. Use the key and enter a value. Push the TARE (Enter) key to store.
5.5.2 Using a Stored ID
1. Press the CODE ( softkey needs to be set up ) key.
2. Counterpart responds with a code #=> with a prompt. Enter the ID code.
3. Press TARE (Enter) .
Note
Press code and then enter a zero to unload an ID code.
5.5.3 Using ID/Codes that are not Stored
1. Enable Single ID under feature menu.
2. Setup softkeys for code and other information to be printed, including part #, description, and/or quantity.
3. Press Softkey .
4. Key in value or information and press Tare (Enter) .
5. The unit weight softkey may be set up to clear unit weight.
6. Next ID/code overrides data.