Rice Lake Counterpart Configurable Counting Indicator - User Manual Rev. E - Version 2.5 - Manual (Page 24)

18 Counterpart Counting Scale Indicator
1. Stand scale base on its side to attach the bracket to the scale using the screws provided in the bracket kit.
2. Ensure that the cable underneath the scale base is threaded through the opening between the scale and the
bracket, otherwise it will not fit.(shown in Figures 2-18 and 2-19).
Ensure the cable from the
underside of the scale is run
between bracket and scale
prior to attaching bracket.
Note
Figure 2-17. Attach Bracket Assembly to Scale Base While Scale Is Tipped on its Side (DIGI S-XL Base Shown).
The DIGI S-YC scale base comes with
notched holes in the bracket assembly.
While plugging in the AC adapter, slide
the bracket assembly forward to allow
more room to work. Once the AC adapter
is connected, slide the bracket assembly
back and finish tightening the screws.
m,
Figure 2-18. Attach Bracket Assembly to DIGI S-YC Scale Base
3. Set scale base down on a flat surface positioning the bracket assembly at the edge of a table.
4. Attach the indicator to the bracket using the second set of screws provided and screw white threaded
standoffs into indicator base as in Figure 2-19 if using the S-YC scale base and then screw feet into the
bottom of the standoffs.
Figure 2-19. Indicator Attached to the Scale Base (DIGI S-YC Scale Base Shown)