Dynon Avionics SkyView Pilots Users Guide - Manual (Page 10)

x SkyView Pilot’s User Guide
Revision Revision Date Description
Q (Cont.) March 2014
Added: Support for MGL V6 and V10 Com radios.
Added: Support for the Trig TY91 Com radio.
Added: Support for Val NAV 2000 nav radio.
Improved: Radios such as the Icom A210 that can receive frequencies but do not output
status now need not cause the top bar radio status area to show a “red x”. Added
DISPLAY COM IN TOP BAR option to configure this behavior.
Fixed: Fuel Tank Switch Reminder is now a message, not a caution alert.
Added: Touch Panel Fault Alert
Added: Special alert behavior for Dual Engine monitoring
Added: “Check gear” and “gear overspeed” audio alerts for retractable gear aircraft that
are tied to both landing gear status and airspeeds.
Added: “Gear up for water landing” and “gear down for runway landing” audio alerts for
amphibious aircraft that are annunciated as a selected airspeed is transitioned through.
Added: Tail numbers for ADS-B equipped traffic will be shown below traffic targets when
available. Only available for aircraft equipped with Dynon's ADS-B receiver, and will only
be shown for target aircraft that are ADS-B OUT equipped.
Improved: Radios such as the Icom A210 that can receive frequencies but do not output
status now need not cause the top bar radio status area to show a “red x”. Added
DISPLAY COM IN TOP BAR option to configure this behavior.
Fixed: Warning, caution, and message alerts that do not have their own dedicated audio
phrases were not annunciating the generic “warning”, “caution”, and “message” audio
phrases they should have been. This bug is present in SkyView 7.0-7.1. It worked properly
previously and is fixed with 10.0.
Fixed: Items that shouldn’t be appearing on the map per the “map items” zoom/range
declutter settings were appearing when the map was very zoomed in.
New: Support for speed-scheduling of the trim control in the SV-AP-PANEL.
Improved: HSI courses are now remembered for each HSI source. This is especially helpful
when switching between VOR and ILS or GPS and ILS sources.
R August 2014
New: Support for SV-COM-X83 8.33 kHz COM radio.
New: Support for Video Input Adapter. Allows display of video via NTSC and PAL S-Video
and composite connections. Note: Only compatible with SkyView Touch and newer
SkyView SV-D1000 (s/n >= 6000) and SV-D700 (s/n >= 4000) displays.
New: Virtual-DME (non-certified) distance to VORs via GPS when the VOR identifier is
known. Magenta distance is displayed on HSI info area on PFD.
New: SHOW AIRSPACES WITHIN XXXX FT option to declutter airspaces that aren’t a factor
at the current aircraft altitude.
New: Wide field of view option for Synthetic Vision under PFD > MODE > WIDE. Setting
also proportionately scales the pitch ladder.
New: Vne can now be set as TAS.
New: Option to turn on color-coded weather “dots” at airports with METARS via MAP
MENU > WEATHER OPTIONS > METAR ICONS (SV-ADSB-470 required).
New: BARO sync will now obtain either the nearest METAR (when ADS-B is available in-
flight), set to 29.92 (when at/above 18k feet or no ADS-B on board), or to make the
altimeter match GPS altitude (when on the ground).
Added: Alert when engine sensor definitions do not match across multiple displays in a
SkyView system.