Dynon Avionics SkyView Pilots Users Guide - Manual (Page 152)

SV-MAP-270 Navigation Mapping Software
7-62 SkyView Pilot’s User Guide - Revision S

MAP ITEMS – Use these settings to specify the largest range level that the various
features are displayed. You may also completely inhibit the display of various items on
the map using this feature.

MAP MODE –
o MAP MODE – Use this setting to specify when the map is displayed in “Track Up”
vs. “North Up” orientations.
o WITH CHART – Use this setting to specify when the map is displayed in “Track
Up” vs. “North Up” orientation on a Geo-referenced chart when enroute charts
are being displayed. Some pilots choose to keep this in North Up to preserve
chart text legibility.
o SHOW VOR AS – Use this setting to choose whether VOR directions are shown as
“bearings” (the direction the VOR is relative to the aircraft position) or “radials”
(what radial the aircraft is on relative to the VOR, with the published deviation of
the VOR station correctly taken into account, like would be seen on a sectional)
when listed on the NRST page.
o INC MAP RANGE – Use this setting to select between clockwise or
counterclockwise to Increasing / decreasing range on the map.
o FULL SCREEN MAP – Use this setting to assign either the left or right joystick
knob to the (MAP) when the Map Page is full screen.

NEAREST LIST OPTIONS – Use these settings to choose whether or not the NRST list
shows full airport names or not, and to adjust what airports the nearest list FILTER
button affects.

FLIGHT PLAN OPTIONS – Use these settings to allow incoming flight plans and set the
ground speed used for ETA calculations while the aircraft is not flying.

TRACK LINE OPTIONS – Use these settings to set up the distance and time markings
shown on the ground track line.

“VS REQ’D OPTIONS” – Use these settings to configure the Vertical Speed Required to
Destination Info block on the map. Select the distance from and the distance above the
last waypoint in the SkyView flight plan and SkyView will continuously compute what
vertical speed you would need to maintain from your present position to converge on
the point above and before the point specified. This information is reflected in the VS
REQ'D DESTINATION Info Item and on the vertical speed tape on the PFD.
Map Info Items

MAIN MENU > MAP > MAP MENU> INFO ITEMS – Use these settings to display up to 10
informational items along the left and right sides of the Map Page Items available for
display include:
o Bearing to Waypoint
o Cross Track
 This is the shortest possible distance that can possibly be traveled that
will put you back on course. Essentially, it is the perpendicular distance
from the current location to the course line.
o Current Location