Dynon Avionics SkyView Pilots Users Guide - Manual (Page 82)

EMS Operation
5-12 SkyView Pilot’s User Guide - Revision S
The column to the left of the circuit name is blank when the circuit is turned off, displays a
green checkmark when it is turned on, and displays a red “X” when there is a fault condition.
The column to the right of the circuit depicts contextual information about the circuit.
Nominally, this is the current draw - in Amps - for circuits that are powered on.
If the circuit is in a fault condition, the fault condition is described. Possible fault conditions for
circuits include:

OVERV: Over Voltage Limit (alternator only)

SHORT: Shot Circuit

OVERC: Over Current

OPEN: Open Circuit
Additional information that is only displayed for flaps/trim includes:

RUNWY: Runaway trim or flaps

ACTVE: Actively moving trim or flaps

DSABL: Trim or flaps disabled
Circuit Control
Whenever the VP-X page is being displayed, the joystick underneath that page lets you highlight
and select each circuit. Simply rotate or move the joystick up and down to select a circuit. If a
fault exists, the first faulted circuit will be automatically highlighted.
When a circuit is selected the menu at the bottom of the SkyView screen automatically changes
to allow control of the circuit.
All Circuits

RESET button: Press this button to reset any circuit that has a fault condition that the
VP-X will allow to be reset. This button will be grayed out and unavailable if the circuit is
not in a fault condition.
Flaps and Trim Circuit Controls

UP and DOWN buttons:
o For Elevator Trim: Moves the elevator trim up or down as described in the VP-X
documentation. This button can be held down for continuous trim movement.
o For Flaps: Moves flaps up or down as described in the VP-X documentation.
Depending on the VP-X configuration, a single quick press of the UP or DOWN
button may move the flaps to a preconfigured angle or notch of flaps. Or, it may
only move the flaps momentarily. This button can be held down for continuous
trim movement.

LEFT and RIGHT buttons:
o For Roll Trim: Moves the roll trim left or right as described in the VP-X
documentation. This button can be held down for continuous trim movement.