Dynon Avionics SkyView Pilots Users Guide - Manual (Page 28)

SV-D700, SV-D1000 and SV-D1000T Operation
3-2 SkyView Pilot’s User Guide - Revision S
Figure 1–SkyView Display Front Bezel Layout
Note the Top Bar, screen, joystick and button labels, light sensor, two joysticks and eight
buttons.
The Top Bar is user configurable and displays important textual information. The Top Bar will
display clock time or a timer (when running), autopilot status, battery status (when an issue
requiring attention is detected), transponder status, and COM Radio status. Reference the How
to Configure the Top Bar Section of this guide for details on how to configure the Top Bar.
The screen shows PFD, Engine, and Moving Map data, configuration information, and system
alerts. Its layout is user configurable. See the Screen Layout Configuration Section for specific
instructions on how to configure the layout of your screen.
Joystick and button labels are also on the screen as seen in Figure 1. Joystick and button
functionality is contextual based on what is onscreen and these labels show the user the current
function. For example, the (MAP) label above joystick #2 in Figure 1 shows that manipulating
that joystick will affect what the user can see on the Moving Map Page.
The set of button labels displayed immediately after the display turns on is referred
to as the Main Menu.
Each SkyView display has an integrated light-detecting sensor in the front bezel. This light
sensor can be used for automatic backlight level management. Reference the SkyView System
Installation Guide for instructions on how to configure the display for automatic backlight level
management.