Dynon Avionics SkyView Pilots Users Guide - Manual (Page 222)

Messages and Alerts
12-6 SkyView Pilot’s User Guide - Revision S
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Engine Monitor” <VP-X channel
name> FAULT
VP-X channel fault
“Warning”
DEMO MODE
System is in Dynon demo mode
and is not airworthy
“Warning”
PITCH SERVO
OFFLINE
The Pitch Autopilot servo has
stopped communicating with
SkyView. Will be seen if Autopilot
servos are not receiving power.
“Warning”
ROLL SERVO
OFFLINE
The Roll Autopilot servo has
stopped communicating with
SkyView. Will be seen if Autopilot
servos are not receiving power.
“Warning”
ARINC-429 OFFLINE
The SV-ARINC-429 module is not
communicating with SkyView.
“Warning” BACKUP BATTERY
LOW
The backup battery connected to
this display is low.
“Warning”
SKYNET POWER
FAULT
A fault has been detected in the
wires that provide power to
SkyView Network devices.
“Warning” AUDIO SUBSYSTEM
FAIL
SkyView has detected a problem
with the audio system.
“Check Canopy Latch”
Check Canopy Latch
A canopy latch alert is configured;
The canopy is not latched; and the
engine has been advanced past a
configured RPM.
“Caution”
STANDBY NETWORK
ERROR
SkyView Network has lost its
secondary standby network
redundancy. See below for more
information.
“Caution” POSITION SOURCE
or GPS X FAIL
Position source (GPS) failure
“Caution” TRANSPONDER FAIL Transponder failure.
“Caution”
XPNDR HEX CODE
NOT SET
A SkyView Transponder or ADS-B
receiver is installed but the HEX
Code has not been set.
“Caution”
EMS SFG FILE
MISMATCH
The Engine sensor indications may
be incorrect and screens may
disagree.