Dynon Avionics SkyView Pilots Users Guide - Manual (Page 225)

Messages and Alerts
SkyView Pilot’s User Guide - Revision S 12-9
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Switch Fuel Tank”
SWITCH FUEL TANK
The optionally-configured fuel
tank timer has reached its pre-
configured time or fuel quantity
consumption limit.
“Timer Expired”
TIMER EXPIRED
A DOWN timer under TOOLS >
TIMER has expired.
“Message” EXT LEVEL BUTTON
STUCK
The external Level Button is stuck
and is inoperative.
“Message”
CHECK BARO
SETTING
The current BARO setting and the
nearest METAR-based altimeter
setting are more than .1 inHg apart.
Or the aircraft has descended below
FL180 and the BARO should be reset.
“Message”
BATTERY TEST
FAILED
A full backup battery test was
performed, and it failed. See the
Installation Guide for further
troubleshooting information.
“Message”
BATTERY TEST
NEEDED
A year or more has passed since
the last successful backup battery
test, or the last three SkyView
shutdowns were abnormal.
“Message”
SOFTWARE
MISMATCH
SkyView components are not all
running the same software
version
“Message” OEM CONFIG
MISMATCH
OEM-customized displays are not
in sync with each other
“Message”
TAIL # MISMATCH
Tail numbers differ between
SkyView displays – settings will
not properly synchronize
“Message” XPNDR NOT IN ALT
MODE
The aircraft is in flight and the
Transponder is not in Alt Mode
“Message”
CPU TEMP HIGH
The display internal temperature
is significantly higher than the
normal operating temperature.
“Message” BACKUP BATT LOW
CHARGE
The backup battery connected to
this display is not charged.
“Gees” (repeats)
None n/a
The G meter is in the yellow
caution range
“Over Gees” (repeats)
None n/a
The G meter is in the red warning
range