Dynon Avionics SkyView Pilots Users Guide - Manual (Page 70)

PFD Operation
4-32 SkyView Pilot’s User Guide - Revision S
To operate the timer once in the TIMER menu:

MIN and SEC knobs: Turn to set the time

BACK: Leaves the timer menu and returns you to the Main Menu

ZERO: Resets the timer to zero

LAST: Resets a DOWN timer to the last value it was set to before it was started

DOWN/UP: Toggles the timer mode. Both count-up and count down timers are
available.
o When a DOWN timer reaches zero, an audible “timer expired” message is played
(if audio output is connected), the timer flashes white for a few seconds, and a
“timer expired” alert is annunciated in the message alert area. Press button 8 to
view and acknowledge this alert. If a DOWN timer is not reset, the timer will
continue to count down negatively.
o When the UP timer is running, it will stop at 99:59 minutes.

RUN: Turns the timer on and off. RUN is highlighted when the timer is on.
SkyView Knob Control Panel Operation
The SV-KNOB-PANEL SkyView knob control panel adds three additional dedicated knobs to the
SkyView system for the most frequently adjusted bugs. One knob is dedicated to each of the
Altitude Bug (ALT), Altimeter Setting (BARO) and Heading/Track Bug (HDG/TRK) on the primary
flight display. These knobs behave exactly like the SkyView joystick knobs do when they are set
to these functions: turn them to adjust the value they control. Press and hold them to
synchronize the ALT and HDG/TRK bugs to the aircraft’s current altitude or heading/track. Press
and hold BARO set the altimeter setting to either the nearest METAR (when ADS-B is available
in-flight), to standard pressure (29.92 inHg or 1013 millibars) (when at/above 18k feet or no
ADS-B on board), or to make the altimeter match GPS altitude (when on the ground).