Dynon Avionics SkyView Pilots Users Guide - Manual (Page 226)

Messages and Alerts
12-10 SkyView Pilot’s User Guide - Revision S
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Traffic Not Available”
None n/a
Traffic is not available from a
previously available source
“Traffic”
None n/a
A new traffic advisory target has
been identified. Note that this
audio alert is suppressed when
not in flight to reduce nuisance
alerts. Other visual traffic alert
indications persist, however.
“Autopilot”
None n/a
The roll or pitch autopilot axis has
been engaged
“Autopilot Mode”
None n/a
The autopilot roll mode has
changed since it was engaged.
This includes sequencing onto an
armed mode (such as an ALT Hold
> VNAV sequence)
“Autopilot Disconnect”
None n/a
The roll or pitch autopilot axis has
disconnected
“Trim Up”
None n/a
The autopilot requires nose up
trim to maintain control of the
aircraft, and has been
annunciating this visually on the
display for at least 30 seconds.
This alert is played a maximum of
once every 30 seconds.
“Trim Down”
None n/a
The autopilot requires nose down
trim to maintain control of the
aircraft, and has been
annunciating this visually on the
display for at least 30 seconds.
This alert is played a maximum of
once every 30 seconds.
“Autopilot Airspeed
High/Low”
None n/a
The autopilot airspeed limits are
exceeded.
“Approaching Minimums”
None n/a
Altitude is within 200 feet of the
MDA bug
“Minimums”
None n/a
Aircraft has descended below
MDA bug
“Approaching Altitude” /
“Leaving Altitude” None n/a
Altitude alerter notification that
the aircraft is approaching or
leaving the bugged altitude