Dynon Avionics SkyView Pilots Users Guide User Manual
Page 211
Advertising
SkyView Pilot’s User Guide - Revision S
11-9
Use the TWR, ATIS, GND, and ATC buttons to send the associated airport frequencies to
the standby frequency location
Loading Airports via the Control Panel
By Nearest
Press the APT button once. NRST APT is displayed on the control panel, and the top bar
shows a list of the nearest airports within 75nm of your current location:
Rotate the small, inner dual concentric knob to the airport you wish to load
Press the dual concentric knob on the control panel to load the airport to the control
panel (or press APT to cancel your selection)
Use the TWR, ATIS, GND, and ATC buttons to send the associated airport frequencies to
the standby frequency location.
Advertising