Dynon Avionics SkyView Pilots Users Guide - Manual (Page 127)

SV-MAP-270 Navigation Mapping Software
SkyView Pilot’s User Guide - Revision S 7-37

APT – Airport

WX – Weather (when a weather device is connected)

VOR

NDB

FIX – Fixes

VRP – Visual Reporting Points

USR – User Waypoints

ATC – Nearest non-airport specific ATC-frequencies, such as centers. Available with FAA
aviation data only.

FSS – Nearest FAA Flight Service Station frequencies. Available with FAA aviation data
only.
Map Items which are set to Off in the MAP ITEMS menu, such as private airports or
seaplane bases, will not appear in the nearest list at all.
Move the joystick left and right among the tabs to select the category you are interested in.
Rotate or move the knob up/down to highlight different items in the list. Once the desired
facility is shown, press INFO for more information about it,
to navigate directly to it, or
ADD->FPL to add it as a waypoint in a Flight Plan. Items that have COM frequencies
associated with them can have their frequencies sent to a connected COM radio by pressing
TUNE COM.
Nearest Airports List Filter and Other Options
The pilot can also apply additional criteria to the list of nearest airports with the FILTER button,
which replaces the NRST button when the list is displayed. SkyView will remember if the filter
was selected when it was powered off and automatically filter the list again on the next bootup.
To see the full list of airports, press the FILTER button again.
To configure the filter, go to MAIN MENU > MAP > MAP MENU> NEAREST LIST OPTIONS

SHOW FULL AIRPORT NAME – Yes/No, turns the full airport name on or off regardless if
FILTER is engaged or not.

WHEN FILTERED – The following restrictions are applied to the nearest list when FILTER
option is active:
o RUNWAY SURFACE – The pilot can choose to display Any Surface, Water only,
Hard and Soft or Hard only when FILTER is engaged.
o PRIVATE AIRPORTS – The pilot can choose to Show or Not Show private airports
when FILTER is engaged.
o MINIMUM RUNWAY LENGTH – The pilot can select a minimum runway length
for airports to be displayed when FILTER is engaged. Runways with unknown
length are not shown when the NRST list is being filtered by runway length.