Toa SX-2000 Series - Manual (Page 104)

104
[ If "External failure input" is selected for "Function"]
(3) Contents (left side)
Select the type of contact input to judge to be a failure.
Note
Assigning this function to a control input terminal enables this terminal to be selected in the "External
failure input" item on the "Failure output pattern settings" screen
(p. 85) .
Break (default), Make Available Settings
EVENT SETTINGS
SM Event Settings
[ If "Emergency reset" is selected for "Function" ]
(3) Contents (left side)
Select the EV message (Type: Reset) to be broadcast by the control input.
Set the EV message using
"System settings System Manager EV Message" (p. 45) .
Setting the EV message to "None" and "Control output pattern" (next item) permits only the control output
to be operated in synchronization with the control input.
None (default), Set emergency broadcast pattern Available Settings
(4) Contents (right side)
Select the control output pattern that operates in synchronization with the control input.
Set the control output pattern using
"Pattern settings Control output pattern settings" (p. 81) .
None (default), Set control output pattern Available Settings
[ If "Emergency sequence phase shift" is selected for "Function" ]
(3) Contents (left side)
Select the emergency sequence to be shifted to by the control input.
Set the emergency sequence using
"Pattern settings Emergency sequence settings" (p. 82) .
Set emergency sequence (default: Sequence 1) Available Settings