Toa SX-2000 Series - Manual (Page 6)

6
To make general-purpose pattern broadcasts, follow the procedures below to perform each setting using the
SX-2000 Setting Software.
Set the output zones to which general-purpose pattern broadcast is made.
When using the output zone pattern, set this in the
"Output zone pattern settings."
When setting the individual output zones, perform this setting in the "General broadcast pattern
settings."
Set the general-purpose broadcast patterns.
Perform this in the "General broadcast pattern
settings."
Set the control output to be interlocked with the control input or key operation. *
Perform this in the "Control output pattern settings."
* Perform this setting as needed.
Assign both the general-purpose broadcast pattern and control output pattern to
the control input or key of the device, or the key on the remote microphone.
Perform this in the "Event settings."