Toa SX-2000 Series User Manual
Page 64
64
SYSTEM SETTINGS
SX-2000AO and SX-2100AO
• EOL (SX-2100AO only)
Set this item when the EOL (End-of-Line) unit is used.
This must be made valid in the speaker line failure detection settings.
Not used (default), Used
Available Settings
Not used (default), Used
Available Settings
(4) Key name
Enter each name of the function keys and channel keys on the SX-2000AO's and SX-2100AO's front
panel.
(5) Control input/output
Enter each name of the control inputs and control outputs of the SX-2000AO and SX-2100AO.
Up to 32 alphanumeric characters. (Default name, for example, AO1-CIN1
represents the SX-2000AO's or SX-2100AO's Control input 1, and AO1-COUT1
represents the SX-2000AO's or SX-2100AO's Control output No. 1.)
Available Settings
Up to 32 alphanumeric characters. (Default name, for example, AO1-FKEY1
represents the SX-2000AO's or SX-2100AO's Function key "F1," and AO1-
CHKEY1 represents the SX-2000AO's or SX-2100AO's Channel key 1.)
Available Settings
(6) Standby amplifier (SX-2100AO only)
This function is available only when the "Surveillance function" is set to "Used" in the "Basic Settings."
• Amplifier
Select the amplifier model number to use, or "Not used."
VP-2064 (default), VP-2122, VP-2241, VP-2421, Not used
Available Settings
• SP line voltage
This setting is valid when the Amplifier model item above has not been set to "Not used."
Select the speaker line voltage.
100 V (default), 70 V, 50 V
Available Settings
(7) Local input (SX-2100AO only)
• Name
Enter the names of the Local inputs 1 and 2.
Up to 32 alphanumeric characters. (Default name, for example, AO1-Local In 1
represents the SX-2100AO's Local input 1.)
Available Settings
• Volume (dB)
Select the sound volume levels for the output zones.
0 (default), –1 to –69, –infinity (in 1-dB steps)
Available Settings
• Pilot tone (20 kHz) (SX-2000AO only)
Set whether or not a pilot tone is used.
Note
"Surveillance function setting" of "Basic Settings" (p. 30)
"Amplifier" of "Output zone settings" (p. 63)
must both be set to "Used."
Note: To set the VP-3000 series amplifiers, select VP-2122 for VP-3154, VP-2241 for VP-3304, and VP-
2421 for VP-3504 since these models do not appear on the pull-down menu.