Toa SX-2000 Series - Manual (Page 19)

19
Step 5. When the Installation Complete dialog is displayed,
click the [Close] button to complete the installation.
[If no installation wizard screen is displayed]
The screen at right may be displayed when the Step 1 is
performed. In this case, install the software needed to run
the SX-2000 Setting Software with the steps below.
Step 1. Click the [Accept] button.
The software installation screen is displayed.
Step 2. Click the [Install] button.
Installation in progress screen is displayed.
As the installation wizard screen is displayed after completion of installation, follow the steps shown on the
previous page .